The staff of Ximike Bearing introduced that the life of three kinds of bearings can be controlled, and the most important thing is to operate and use them correctly. Here are some points for attention.
1. Accurately control the concentration of cutting fluid. When the machine tool stops working, the clean machine tool appearance is washed with cutting fluid, and the machine tool shield is opened to remove the wet air in the machine tool working area. In order to avoid the occurrence of electric erosion, a layer of waterproof smooth grease should be applied on the metal surface.
2. Avoid bearing corrosion. When directly taking the bearing by hand, it is necessary to wash the liquid abundantly from the hand and apply high quality mineral oil before operation. In dry season and summer, special attention should be paid to rust prevention. Under some special operating conditions, three types of bearings can obtain better life than traditional accounting, especially under light load conditions.
3. Use appropriate and precise devices to make the best use of special things; try to avoid using cloth and staple fibers and other things. When using the device, we should be careful not to allow strong stamping, not to use vertical connection to knock on the bearing, and not to allow pressure transmission through rolling bodies.
4. Stick to the hygiene of the bearing and its surroundings as far as possible. Even if the invisible laughing dust enters the bearing, it will add wear, vibration and noise of the bearing. In order to avoid the multiplication and multiplication of bacteria, cutting fluid should be replaced regularly and hygienically, chips should be removed in time, and cutting concentrate should be diluted with soft water (pure water with low mineral content).
